Request a Quote

Zinc Die Casting

Zinc die casting for smaller and thinner-wall parts that need fine as-cast detail — hardware, fittings, levers and covers. The process route matches aluminum casting; the difference is in the alloy, the machine cell and how the part is finished. We match the alloy and the cell to the part, not the other way round.

Photographs show the part families; alloy, wall thickness and finish for your part are fixed on the drawing.

Window frame, two finishes Three-bore bracket Rocker arm

Service scope

Wall section, gate position and finish are reviewed together.

  • Hardware and fittingsLevers, handles and small mechanical parts where fine as-cast edges reduce the amount of finishing work.
  • Thin-wall coversSmall covers and caps where wall section and gate position are reviewed together to avoid sink and short fills.
  • Parts that will be plated or paintedSurface appearance and handling requirements are reviewed before tooling, because the finish is judged on the part, not only on the drawing.

Representative parts

Fittings, flanges and small components from zinc runs. Photographs show geometry and finish; alloy, wall thickness and plating are fixed on the drawing.

View the full part library

Capabilities

What the zinc route covers: fine as-cast detail, thin walls, and parts that will be plated or painted.

  • Tooling in-house Mould design and manufacture for the zinc casting cells.
  • Fine as-cast detail Levers, handles and fittings where sharp cast detail reduces finishing work.
  • Wall section reviewed Wall thickness and gate position reviewed together to avoid sink and short fills.
  • Plating and painting Finish requirements reviewed before tooling, then quoted with the project.
  • Checked before the run Trial parts checked for fill, detail and dimensions before production.
  • Typical parts Handles, levers, fittings and small covers.

Production route

Zinc follows the same approval order as aluminum, with finishing added between casting and inspection.

01
Drawing review Wall section, draft, parting line and finish requirement.
02
Tooling Mould design for a zinc cell, including gate and runner layout.
03
Trial and sample approval Trial parts checked for fill, detail and dimensions.
04
Die casting Production on the zinc cell.
05
Finishing and assembly Polishing, plating or painting where the drawing specifies it, inspected against the agreed appearance standard and assembled where the part is multi-piece.
06
Inspection and delivery Dimensional and appearance checks against the agreed plan.

Inspection

Zinc parts are judged on fill, as-cast detail and the finish that follows, so appearance is checked against an agreed sample.

  • Appearance standardPlated and painted parts are checked against the appearance standard agreed at quotation, on the faces the drawing calls critical.
  • Wall section and fillThin walls and fine detail are checked on trial parts before the tool is released for production.
  • Trial and sample approvalTrial parts are approved for fill, detail and dimensions before the zinc cell runs the order.
  • Finish recordsFinish and dimensional records agreed for the project travel with the shipment.

Dimensional checks use callipers, plug and thread gauges and CMM where the drawing calls for them; plated surfaces are checked against the finish specification.

Questions engineers ask

Zinc is usually considered for smaller parts that need fine detail or a thin wall, and for hardware that will be plated. It is not automatically cheaper: part size, cavity count and finishing all change the comparison. We recommend a material review before tooling.

No. A single figure would be misleading, because wall thickness interacts with part size, flow length, alloy and gate design. It is checked on the actual drawing.

Plating, anodising and painting are quoted per project with qualified finishing suppliers and inspected against the appearance standard agreed with you. Tell us your finish specification at quotation and it becomes part of the price and the inspection plan.

Yes, if the part can be measured and a drawing or 3D model can be produced. Reverse-engineering a competitor part requires enough geometry to define it properly; a photograph alone is not sufficient.

Have a drawing for this route?

Include the material, quantity and the features that matter. If the drawing is confidential, ask for the NDA step before sending it.